Jetson Orin Nano

Compared to Jetson Nano it also has

Jetson Orin Nano Developer Kit Carrier Board

Camera	2x MIPI CSI-2 22-pin Camera Connectors
M.2 Key M	x4 PCIe Gen3, 2280
M.2 Key M	x2 PCIe Gen3, 2242
M.2 Key E	PCIe (x1), USB 2.0, UART, I2S, and I2C
USB	Type A: 4x USB 3.2 Gen2, Type C: 1x for Debug and Device Mode
Networking	1x GbE Connector
Display	DisplayPort 1.2 (+MST)
microSD slot	UHS-1 cards up to SDR104 mode
Others	40-pin Expansion Header (UART, SPI, I2S, I2C, GPIO), 12-pin button header, 4-pin fan header, DC power jack
Dimensions	100 mm x 79 mm x 30 mm(Height includes feet, carrier board, module, and thermal solution)
POWER	4AMP 19V

Make sure to have host machine Ubuntu v22. Higher versions will not work with SDK
Install Nvidia SDK manager
Under Jetson CPU chip, connect FC REC and GND pins to run device in reset mode
Connect USB-C port of the jetson with USB3 port of your host machine. Prefer fast cables, as USB-2 cable will be very slow
Run Jetson
Run NVidia SDK manager, that should detect the device
Check almost all checkboxes
After half of the installation is complete, SDK will ask about IP .
- You now need to login into jetson (so connect display, mouse, keyboard)
- Attach ethernet cable to jetson or connect via wifi. Run ifconfig and get its IP.
- Make sure host machine and jetson are in the same network
- In SDK manager, enter jetson IP so that it can install remaining software